2016-2017 Ford Mustang GT 5.0 6R80 Automatic Transmission Conversion Kit Auto
The 2016-2017 Ford Mustang GT 5.0 6-speed Automatic Transmission Conversion Kit includes everything you need to convert your Ford Mustang GT 5.8L V8 engine into a manual transmission. The kit comes complete with all necessary parts to convert your automatic transmission into a standard clutch. All you have to do is install the conversion kit into your vehicle and add a new clutch master cylinder.
Ford Mustangs have been around since 1964, and they still hold strong today! In fact, if you go to any car show, you’ll find at least one Mustang on display. The Mustang is known for its muscle car design and great performance. If you want to make your Mustang look even better, then check out our conversion kit. We’ve got everything you need to convert your automatic transmission to a manual transmission. Just follow these simple steps:
Step 1 – Remove the existing transmission
First thing’s first, remove the old transmission. You can do this by removing the two bolts holding the shifter in place. Then pull the shifter back and out of the way. Next, disconnect the wiring harnesses and the shift cable connecting the shifter to the transmission.
Step 2 – Install the transmission
Next, install the transmission. First, slide the transmission over the engine block. Then, use the supplied torque wrench to tighten the bolts securing the transmission to the engine block. Use a socket wrench to tighten the bolts attaching the trans cooler bracket to the intake manifold. Finally, attach the shifter to the new transmission using the provided hardware.
Step 3 – Connect the cables
Now that the transmission is installed, connect the wires to the new transmission. Start with the clutch wire, followed by the brake line. Connect the remaining parts in order starting with the fuel pump, followed by the throttle body and lastly the ignition coil. Once finished, test drive your Mustang!
Step 4 – Adjust the shifter position
To adjust the shifter position, loosen the bolt located under the shifter arm. Slide the shifter forward until you reach your desired gear. Tighten down the bolt once again. Repeat this step until you’re satisfied with the position.
Step 5 – Test Drive
Once you’re done adjusting the shifter, test drive your Mustang. Make sure everything works properly before proceeding to the final step.
Step 6 – Final Preparations
Before installing the final piece of the transmission, we recommend adding some oil to the transmission case. Add enough oil to cover the entire interior of the transmission case. Be careful not to add too much oil, just enough to coat the inside of the transmission case.